Elbow is divided into cold stamping and hot stamping two kinds, according to the material properties and equipment capabilities to choose hot and cold stamping, cold stamping elbow is the use of a dedicated elbow forming machine, and then put the tube billet in the external mold, the upper and lower mold after the push

Test method for clearance and rotational flexibility of pipe fittings The measurement of the radial clearance of the whole tube is not easy, the measuring force causes the ring and the rolling body and the contact place to produce the elastic deformation, the deformation amount is the many factors that cause the measurement error, it

Weld neck flange problem Today, a friend consulted: after welding neck flange welding, found that the internal welding slag and Burr can be cleaned? Pipe and flange material is 316L, welding all used argon arc welding, after welding not only burr exists, there is no penetration of the situation, why so? Is the welder level

Type and function of flange gasket Commonly used flange gaskets are divided into three main categories: 1. Non-Metallic gasket A, Asbestos rubber gasket Features: Good elasticity, high strength, good oil resistance, high temperature resistance, easy access. But asbestos products can cause cancer. Scope of application: T≦260℃, pn≦2.0mpa (SH3401), T≦400℃, pn≦4.0MPa (gb/t539), used in water, air,

Plate slip on flange (chemical standard HG20592, national standards gb/t9119, Machinery jb/t81): Easy to draw, simple to manufacture, low cost, wide use, but the rigidity is not good, so it can not be used for supply and demand, flammable, explosive and higher vacuum requirements of the chemical process piping system and high, extremely hazardous occasions. The

Stainless steel slip on flange is convenient, simple to manufacture, low in cost and widely used, but the rigidity is poor, so it can not be used in the chemical process piping system with the requirement of supply and demand, flammable, explosive and high vacuum degree, and high and extreme harm. The sealing type has

Manufacturing high-pressure elbow pipe material needs some special raw materials for production, these raw materials to be tough choice and control, raw materials to choose the right, otherwise the production of high-pressure elbow will not have quality assurance. High-pressure elbow bend Pipe Application Data is a large class of special electricity, the new data of

1. Hot-Push forming Hot-push elbow forming process is the use of special elbow push machine, core mold and heating device, so that the billet on the die in the push machine pushing forward movement, in the movement by heating, expanding and bending forming process. The deformation characteristic of the hot-push elbow is to determine the

High-pressure pipe fittings are used in specific environment such as high-pressure steam equipment, chemical high-temperature high-pressure pipelines, power plants and nuclear power plant pressure vessels, high-pressure boiler accessories. Pipe fittings are the general designation of parts that connect, control, change direction, shunt, seal and support in piping system. Pipe Use classification 1. Pipe fittings For

The quality of different-diameter tube high-pressure pipe fittings should conform to the current national standard “steel butt welded Seamless pipe” GB/t 12459-2005, the roundness of the reducer should not be greater than the corresponding end diameter of 1%, and allow the deviation of the ±3mm; the permissible deviation of the size of the reducer shall